A36F - La Marche A36F Single Phase Battery Charger

A36F - La Marche A36F Single Phase Battery Charger Simple Type: Battery...

Request Quote
For Price

Part Number:: A36F
Model Number:: A36F
Make:: LAMARCHE
Lead Time:: Available
Qty In Stock:: Available

La Marche A36F Single Phase Battery Charger Simple Type: Battery Charger

The La Marche Model A36F is a filtered controlled ferroresonant float charger designed to power a load while charging a battery in telecommunication applications and may be used without a battery and connected as a battery eliminator. The all solid state electronic control circuit provides excellent line-load voltage regulation, current limiting, and alarm contacts with status indicators. The Model A36F is available in a wide range of single and three phase a.c. input voltages, with 12 volt, 24 volt, and 48 volt d.c. outputs in output currents ranging from 10 to 400 amps.

For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.

Features

None Available

Specifications

General

Current limiting: A circuit adjustable from 90% to 115% of rated load, limits the d.c. output current. Factory set at 115% of rated output. Short Circuit A “NON “ type fuse with rating listed in Table 1 is located in the negative output leg of the rectifier, on a positive ground system. On a negative ground system, the fuse is located in the positive output leg.
Equalize: 2.25 - 2.40 volts/cell +/- .1 volts (Lead). 1.50 - 1.60 volts/cell +/- .1 volts (N.C.)
Filtering: For all conditions of input voltage and output load, output noise is less than 32 dbrn “C”-message weighting and output ripple does not exceed 30 millivolts (rms), on batteries rated in ampere-hours at four (4) times the rated charger current. Less than 22 dbrn measured in accordance with REA form 524. The model A36F has less than 32 dbrn “C” message weighted with no battery connected.
Float: 2.12 - 2.3 volts/cell +/- .1 volts (Lead). 1.39 - 1.45 volts/cell +/- .1 volts (N.C.)
High-Voltage Shutdown: A circuit provided for load protection which causes the rectifier to shut down should its output voltage exceed a preset value.
Humidity: This rectifier is capable of operating in an ambient relative humidity range of 0-95% (non-condensing).
Input AC Votage: Taps are provided for nominal single phase a.c. input voltages of 120/208/240 v.a.c., with an a.c. input voltage range of +/- 10% of nominal. The 10, 12,15, 20, 25 and 30 amp 12 volt, the 10, 12, 15, and 20 amp 24 volt, and the 10, 12, and 15 amp 48 volt models are 120 v.a.c. input only. The 150, and 200 amp, 48 volt models are rated for 208/240 v.a.c. only.
Input Frequency Range: 57 to 63 Hz. (60 HZ nominal). 47 to 57 HZ. (50 HZ nominal)
Input Protection: A two-pole circuit breaker opens both sides of the a.c. service for 208 or 240 or the phase side of 120 v.a.c. service on single phase units. Three phase units have three pole a.c. breakers for inputs 240 Vac and lower and four pole breakers for over 240 Vac
operating Ambient Temperaure: 0-50 degrees C (32-122 degrees F)
Paralleling: This rectifier will parallel with any other La Marche Model A36F Charger.
Regulation: Steady state output voltage remains within +/- 1/2% of rated voltage for any load current from no load to full load and for input voltages within the rated range
Remote Sensing: The point of output d.c. voltage sensing may be moved to battery or power board terminals to compensate for voltage drops in cables (See Section 8.3)
Single Phase Output: 10, 12, 15, 20, 25, 30, 50, 75, 100, 150, 200 amps. 12 Vdc or 24 Vdc or 48Vdc
Storage Temperature: 40 to +85 degrees C (-40 to +185 degrees F)

Applications

None Available

Aliases

None Available

LA MARCHE Industrial Partner